- Hp smart array p410i controller disk status commands serial number#
- Hp smart array p410i controller disk status commands driver#
Once the SCSI core is engaged by the driver, it cannot be disengaged This is best done via an initialization scriptīut could vary depending on distribution).
Hp smart array p410i controller disk status commands driver#
The SCSI core may not yet be initialized (because the driver is a blockĭriver) and attempting to register it with the SCSI core in such a case Which the "block" side of the driver creates as The driver must be directed to dynamically engage the SCSI core via the Tape drives with your Smart Array 5xxx controller.Īdditionally, note that the driver will not engage the SCSI core at "SCSI support" in your kernel configuration to be able to use SCSI You must enable "SCSI tape drive support for Smart Array 5xxx" and SCSI sequential access devices and medium changer devices are supported andĪppropriate device nodes are automatically created (e.g., SCSI tape drive and medium changer support sys/bus/pci/devices//ccissX/cXdY/usage_countĭisplays the usage count (number of opens) of logical drive sys/bus/pci/devices//ccissX/cXdY/raid_level
Some models of Smart Array are not able to honor this parameter.ĭisplays the 8-byte LUN ID used to address logical drive "reset_devices=1" kernel parameter will not be honored. The "reset_devices=1" kernel parameter (used by To discover any new, removed, or modified logical drives.Ī value of 1 displayed in this file indicates that When this file is written to, the driver rescans the controller sys/bus/pci/devices//ccissX/cXdY/block:cciss!cXdY
Hp smart array p410i controller disk status commands serial number#
sys/bus/pci/devices//ccissX/cXdY/unique_idĭisplays the SCSI INQUIRY page 83 serial number for logical driveĭisplays the SCSI INQUIRY page 0 vendor for logical drive Max # commands on controller since init: 2įiles in /sys /sys/bus/pci/devices//ccissX/cXdY/modelĭisplays the SCSI INQUIRY page 0 model for logical driveĭisplays the SCSI INQUIRY page 0 revision for logical drive dev/cciss/c1d1p3 Controller 1, disk 1, partition 3 dev/cciss/c1d1p2 Controller 1, disk 1, partition 2 dev/cciss/c1d1p1 Controller 1, disk 1, partition 1 dev/cciss/c1d1 Controller 1, disk 1, whole device dev/cciss/c0d0p3 Controller 0, disk 0, partition 3 dev/cciss/c0d0p2 Controller 0, disk 0, partition 2 dev/cciss/c0d0p1 Controller 0, disk 0, partition 1 dev/cciss/c0d0 Controller 0, disk 0, whole device | +- Partition ID (0=wholedev, 1-15 partition)
Run from the Smart Array's option ROM at boot time. Or the Offline ROM-based Configuration Utility (ORCA) Is a block driver for older HP Smart Array RAID controllers.ĭriver from attempting to drive any controllers that theĭriver is capable of controlling, which is to say, theĭriver is restricted by this option to the following controllers:ĭriver supports the following Smart Array boards: